Canadian Association of Consulting Energy Advisors (CACEA)

  • Home
  • HOT2000 crashes when trying select a P9 system

HOT2000 crashes when trying select a P9 system

  • 28 Sep 2024 4:48 PM
    Quote
    Message # 13413233
    Gilles Lesage

    Hi all. I have been experiencing issues when modeling a P9 system. When selected and clicking OK in the hot water dialog pop up, hot2000 closes.

    tried v11 12 and 13.

    anyone else? 
  • 29 Sep 2024 1:49 AM
    Quote
    Reply # 13413292 on 13413233
    Sanjeev Batta
    Usually it is because cod file is not is same folder as P9.enc. If you copy cod file in StdLibs where P9.enc is located will resolve this issue.
  • 2 Oct 2024 11:53 AM
    Quote
    Reply # 13414657 on 13413233
    Angela Bustmante

    It may be asking about capacity.  If the space heating capacity is under the total heatloss for the house it will change to add in an additional P9 system.  I have not had any crashes but I could see this being an area that could.


    1 file
© 2020 CACEA - Canadian Association of Consulting Energy Advisors. All Rights Reserved.
Powered by Wild Apricot Membership Software