911 equipment that is in the NRCan searchable list do not all appear in v11.11 under CSA P911.  Once you make a P911 report manually in Hot2000 it only saves the file you are in.  So if you change to another P911 set you have to re-enter it all again.

While in the P911 and choosing equipment whether it was from the drop down or manually entered and the "input capacity" was less than what Hot2000 calculated for the capacity required, it prompts a question about wanting to increase the capacity.  If you say Ok it carries on.

However, when you go back out and then back into the P911 equipment you'll notice that Hot2000 automatically changed it from 1 system to 2 systems installed under P911.  Changing the gigajoules drastically (like 10-20 gigajoules).

I do not recall this happening in v11.10.  It may be a design safety feature for not undersizing combo units but frankly I'm not so sure Hot2000 is capable of that.

Will bring it up on the technical committee but wanted awareness.  This effects NETZERO and ENERGY STAR combo systems.